Use and Care Manual

Programming Key

 Time of Day Indicator

∗ LED, displays the time of day.

∗ LED flashes, reset the time of day, see page 17, after electrical service has been interrupted for 3 days or more.

 Button Lock Indicator

∗ LED on, indicates the buttons are locked.

and buttons simultaneously for 3 seconds until the LED turns off.

∗ To unlock, press and hold both 

Program Mode Indicator

or buttons to view all values. ∗ LED on, enter program display mode. Use

∗ LED Flashes, enter program set mode. Press or buttons to adjust values.

 Menu/Confirm Button

∗ Press , the LED turns on; enter program display mode, press

or to view all values.

LED flashes; enter program set mode and press or to adjust the

∗ In program display mode, press the

values.

∗ Press after all program features are set. 

Manual /Return Button

∗ Press the

button in any status and the valve will proceed to the next step. (Example: Press the button while the

button while in Backwash status and the

valve is in Service status and it will start a manual regeneration. Press the

valve will go to Brine & Slow Rinse instantly.)

∗ Press the

 Down and Up Buttons

∗ In program display mode press

∗ In program set mode press

or buttons to view all values.

or buttons to adjust values.

∗ Press and hold both

and

button in program display mode and it will return to In Service. button

in program set mode and it will return to program display mode.

MASTER PROGRAMMING

while adjusting the value and it will return to program display mode directly without saving value.

buttons simultaneously for 3 seconds to unlock the programming functions.

A flashing dynamic display stripe indicates the waster softener is in service

A steady dynamic display stripe indicates the water softener is in the regeneration cycle