Product Manual

9. Mount the brake assembly to the brake flange with the mounting bolts.
Mounting bolts should torque to 40 fps.
10. Inspect the original hub. Check the seal & bearings for wear. if there is any doubt
whatsoever, go ahead and replace the seal and bearings and repack with
fresh grease.
11. Reinstall the hub. Push the hub back into place. Make sure your bearings are seated.
12. Install the washer and use a new tang washer. It is always a good idea to replace it,
just like a cotter pin.
13. Reinstall a castle nut, run it down until it stops. Rock the hub back and forth a little
bit. Spin the hub a little bit. Make sure everything is seated. Run the castle nut down
until it stops and then back off to the next notch, whichever you can use one of the
tabs on the tang washer bend it down into the castle nut.
Electric Brake
“Left” Drivers Side
Electric Brake
“Right” Passengers Side
Drum Brake Installation
Hydraulic Brake
“Left” Drivers Side
Hydraulic Brake
“Right” Passengers Side