Instructions / Assembly

404-344-0000 • tiedown.com
605 Stonehill Drive SW, Atlanta, GA 30336
[e-mail]
Page 3 of 8
TP250 Carriage Assembly Instructions
Carriage Base
Insert Safety Pins
from the inside
of the carriage
Support Strut
Beveled End
Beveled End
Support Slots
Round End
Platform
Base
Platform Back/Flap
Platform
Back/Flap
Step #3
Lift up one side of the carriage 90˚
and let it rest on its side.
Place the round end of the
support strut in the platform
(underside) base, align with
mounting holes.
The support strut must be
positioned with the beveled
end as shown right.
Insert
5/16”x 2” Bolt through
base and strut. Tighten nylock
nut with the bolt.
Important: Do not over-tighten
nylock nut so tight as to
prevent free movement.
Flip the carriage assembly 180˚.
Repeat for second support strut.
Step #4
Flip the carriage on its side with the
carriage base - wheels down and the
back/flap on flat ground.
With both hands, hold the beveled end
each of the support struts. Slide the
struts upward while holding the strut
and the carriage base with your
hands. Insert the beveled end strut
into the slots on the carriage base.
Step #5
From the inside of the carriage base
insert safety pins for both support
struts (labels indicate pin location).