Instructions / Assembly

Page 2 of 8
TP250 Carriage Parts Description List
TP250 Carriage Assembly Instructions
Carriage Base
Carriage Base
Carriage Base
Plywood Brackets
Platform Base
Platform Base
Platform Base
Back/Flap
Platform Back/Flap
Platform
Back/Flap
Platform Back/Flap,
Pivot Tab Holes
Description Qty.
Platform Back Flap 1
Platform Base 1
Carriage Base 1
Support Struts w/Pins 2
Plywood Brackets w/Pins 2
5/16”-18 x 2” Bolt 4
5/16” Nyloc Nuts 4
Step #1
Place the Carriage Base (wheels upward)
and Platform Base (Smooth flat top upward)
on a hard flat surface. Place both bases back to
back so the pivot tab holes align with each other.
Position the Platform Back/Flap at a 90˚ angle.
The Back/Flap should have the smooth flat
surface facing the smooth flat surface of
the platform base. Align the pivot tabs/holes with
Back/Flap/Carriage/Platform. The Back/Flap will
overlap both carriage and platform base tabs.
Step #2
Insert 5/16” x 2” Bolt through all three
tab holes (Back/Flap, Carriage and Platform
bases). Tighten nylock nut with the bolt; not
so tight as to prevent free movement.
Repeat #1 and #2 for opposite side.
Support Struts
(TP400 on page 5)
(TP400 on page 5)