Specification Sheet

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com (404) 344-0000 Fax (404) 349-0401

TMTM

www.roofzone.com

Made in the U.S.A.

by Tie Down Engineering

Tri-Leg Folding Warning Line System - Part #65017

CAUTION - This is a perimeter warning line system only and must

not be used as a guard rail. Warning line shall be erected not less than

6 ft. from the roof edge. Pennant/ﬂags should be rigged and supported so

that the lowest point is no less than 34 in. and the highest point is no

more than 39 in. from the working surface. In order to be OSHA Compliant,

this warning line requires an 18 lb. minimum ballast on the inboard leg.

For complete guidelines consult OSHA 1926.501/1926.502 Fall Protection

Standard as well as both State and Local requirements.

PAGE 1
TM www.roofzone.com Tri-Leg Folding Warning Line System - Part #65017 CAUTION - This is a perimeter warning line system only and must not be used as a guard rail. Warning line shall be erected not less than 6 ft. from the roof edge. Pennant/flags should be rigged and supported so that the lowest point is no less than 34 in. and the highest point is no more than 39 in. from the working surface. In order to be OSHA Compliant, this warning line requires an 18 lb. minimum ballast on the inboard leg.