Technical Specifications

[phone] • Fax [phone] • www.tranzsporter.com
8
Assembly Instructions for the TP400 Hoist
Double back/feed end
cable through pully on
the back of carriage
(cross bar)
Feed end cable
t
hrough pully
Unwind cable
from the back
Attach cable to
the back side of the
pully bracket
Step 8
From the back side of the hoist, remove the end of the cable from
the drum (shown right). It helps to attach the brake handle, use the
brake handle back releases the brake drum. The cable will then
easily un-spool. Staying on the outside (back) of the base section
and track section, take the cable to the top of the last track section
where the top cap pulley is attached.
Step 10
Remove the nyloc nut/washer/lock washer, from the
top cap assembly, place the eye end over the bolt,
replace the washer/lock washer and tighten the nyloc
nut as shown right.
Bolt
Cable Eye/End
Nyloc Nut
Cable is
looped around
carriage pully
Lock Washer
Washer
Top Cap
Step 9
Feed the cable end through the pulley as shown above,
and down the front side of the track section to the
back of the carriage assembly.
Feed the cable end through the pully on back of
TP400 carraiage. Return the cable end to the top cap.