Installation Instructions

Tie Down Engineering • 255 Villanova Dr. SW • Atlanta, Georgia 30336
5
4. Thetopcapisboltedtotheendofthelastsectionoftrack
 sectionyouintendtouse.Assembleasshownrightusing
 two3/8”x3/4”hexheadboltswithlocknutsprovided.
7. Afterthetracksectionwithbaseisproperly
 securedtotheworksiteandproperlybraced,the
 motorassemblycanbeattachedtothebaseunit.
 Thefootpadslidesunderthebasesection,while
 “hanging”themotorbaseasshowninpicture8.
Picture7
Picture8
5. Attachsliceplatestothebottomsectionofthetrack.
Splice plates are mounted on the outside track
section.Slidethetopsectiontrackintothegroveson
 theinsidetracksection,attachwith2nutsandbolts
 perside.Shownleft.
6. Fromthebacksideofthehoist,removetheendofthecablefromthedrum.Ithelpstoattachthebrake 
 handle,pullingbackreleasesthebrakedrum.Thecablewilltheneasilyun-spool.Stayingontheoutside
 ofthebasesectionandtracksection,takethecabletothetopofthelasttracksectionwherethecap 
 andpulleyareattached.Feedthecableendthroughthepulleyasshowninpicture6,anddownthe
 frontsideofthetracksectiontothebackofthecarriageassembly.Attachtheendofthecabletothe
 carriageassemblyasshowninpicture7.
Picture6