Use and Care Manual

13
WARNING
!
WALL ANCHORING
GUIDE
Attaching your furniture to cavity wall with anti-tipping device
Mark the attachment point(s) with a pencil at the appropriate height.
Electric drill
Fixing hole
(round)
Threading hole
(oval)
27/64”
(10.5mm)
1/8”
(3mm)
Drill 1/8-inch (3mm)
diameter pilothole(s) into
the wood stud(s), at the
height you marked with
pencil.
Drywall or plaster with
available wood stud
Drill 27/64-inch
(10.5mm) diameter hole
(s) through the wall at the
height you marked with
pencil.
Drive the plastic plug(s)
into the hole(s), using a
hammer if needed.
Drive the plastic plug(s)
into the hole(s), using a
hammer if needed.
Drywall without available
wood stud
Follow the appropriate pictogram instructions on the following pages,drive the screw(s) with washer(s)
through the brackets and tighten screw(s) firmly into the plastic plug(s) in the wall. Do not over-tighten.
If your wall material is not listed here,
or if you have any questions,consult your local hardware store.
Drill 27/64-inch
(10.5mm) diameter hole
(s) 2-inches (50mm)
deep into the wall at the
height you marked with
pencil.
• •
•
•
•
ANTI-TIPPING DEVICE
The hardware you should use to secure your furniture to the wall
depends on both the type of furniture you have and your wall material.
Using the guide below, identify your wall material and choose the
correspongding steps.
Anti-tipping device bag
(not provided)
Type of Wall Material
Masonry