Installation Guide

11
/
12
6.Troubleshooting
A.No action after turn on the machine.
(1) Check the plug whether it connects well or whether it is broken.
(2) Check the fuse whether it has been burned out.
(3) Check the power switch or digital controller whether it is broken.
B.Indicating light is on but the display screen is black.
(1)Check the 5 cables of railway transformer. The connection is poor if it is loose,
just fix it. The transformer may be faulty if the cable is well connected just fix it.
C. The display screen is working well but the temperature is not
heating up.
(1)Check if the indicating light of solid-state relay is on, if not, please check
whether the relay or digital controller is broken.
(2)The heat plate still can't heating up if you already changed the new solid
state-relay, please check whether the heat plate is faulty or the heat plate's
power cable is loose. If so, it will need to change a new heat plate.
D.Pale Color: The temperature is too low/the pressure is not correct/or not
pressed long enough.
E.Part Blurring of Pattern: Heat was not distributed correctly through heat
plate. Allow more time between press operations. Pressure distribution can also
be the cause, which can be set on the four plate surface adjusters. Please note
that it has been factory set and there should be no need to adjust them.
F.Dull Surface of Pattern: The pressure is too lager or the temperature is too
high.Scarred Pattern:Transfer time is too long.
G.Different Pattern Color: The pressure is not correct or the transfer paper is
poor quality.