Heat Press Machine ─ User Guide ─ Made in China 1 / 12
CATALOGUE 1. Parts List ------------------------------------------3 2. Assembly---------------------------------------3-4 3. Heat Press Machine Introduction--------------4-6 4. Printing Methods ------------------------------6-8 5. Temperature/Time Setting----------------------9 Recommended Temperature/ Time Setting ---------------------------9 Power on-----------------------------------------------------------------------10 Temperature and Time Setting------------------------------------------10 6.
1. Parts List Heat Press Machine Controller Panel Handle 2. Assembly A. Put the handle onto the right position and fix it by 2 screws.
B. Insert the controller into right position of 4 holes from the machine. C.Connect the power line. 3.
Fahrenheit Celsius Switch to Fahrenheit/Celsius Start Switch Notes:The default temperature of this machine is 200℉/30 seconds.
Pressure Adjustment 4.Printing Methods 1. Pull up the handle。 2. Press the power switch when the power is turned on。 Power Switch 3. Press "SET" key, then press "+" key to adjust the temperature (Take 356℉ as example), set the time you want (30s by default), and then press "SET" key, wait for the machine to heat up 4.
Pattern clothes 5.Put down the handle 6.Press the star switch to transfer,and start timing.
7.Timer alarm when finished, seeing the “time area” shown “30”. (30s by default)). Pull up the handle and pull out the Heat Press Platform, take out the clothes, tear off the pattern. Repeat steps 4 to6 to continue printing. Notes: The machine will automatically shut down if it is in standby for more than 30 minutes. If you need to transfer again, just cut off the power and re-start.
5.Recommended Temperature/ Time Setting Set the temperature and time according to the table below and get the specific corresponding temperature and timing setting.(Temperature is measured in Degrees Fahrenheit.) Object Fiber/Fabric/Polyester/Cotton (T shirt/ Mouse Pad) Metal Card/Aluminium Card Temperature Time Application 320℉ (160℃) 15s Heat Painting Film 330℉ (166℃) 15-20s HTV Vinyl 340℉ (172℃) 50-60s Sublimation Transfer Paper 356℉ (180℃) 60s Metal Card A.
(1)Power on The device is 110V-120V 1350W. Choose the right power supply first, insert the power line into the "power socket" and give the device electricity. (2)Temperature and Time Setting Press"SET" key, and press ”-” “+” key to set the required temperature, press “SET” key , and press “-” “+” key to set the required time; Press the “SET” again.
6.Troubleshooting A.No action after turn on the machine. (1) Check the plug whether it connects well or whether it is broken. (2) Check the fuse whether it has been burned out. (3) Check the power switch or digital controller whether it is broken. B.Indicating light is on but the display screen is black. (1)Check the 5 cables of railway transformer. The connection is poor if it is loose, just fix it. The transformer may be faulty if the cable is well connected just fix it. C.
Note: The time and temperature of different products is different. Please strictly follow the parameter settings provided by the material supplier, otherwise the desired result might not be achieved. 7. Warning ① Please select the appropriate power supply and socket in strict accordance with the parameters ② When the Machine is not working, it must be placed in the pallet disk and must not be placed directly on the surface of other objects.