Use and Care Manual

Ticor

1. Unpack the new sink and check the contents of the materials supplied. Your sink should

include a cut-out template and installation hardware.

2. The Supplied cutout template provides two options of installation.

A. Flush mount: Sink edge is ush with countertop opening. To achieve a ush mount

installation, cut along the perforated line of the template.

B. Reveal mount: Sink rim is exposed approximately 1/4” from edge of counter top opening.

To achieve a reveal mount, leave the perforated line along the template.

3. Use the appropriate template for your sink model and desired installation option. Place the

template in the desired position on your countertop. Position the center of the bowl over the

cabinet and faucet holes.

4. Trace the outline of the template and cut the countertop along the inside of the line using the

appropriate cutting tools. The template is a guide only. Use the actual sink to ensure an accurate

cutout hole.

5. Locate and drill holes on the underside of the counter top, approximately 1” from the edge

of where the sink is to be installed. Holes should be evenly spaced approximately 6” to 8” apart

starting from every corner as shown. It is recommended to install a faucet at this point before

installing the sink.

6. Loosely attach mounting brackets to the countertop, parallel to the cutout opening using proper

fasteners.

Undermount Sink Installation

C O U N T E R T O P

UndermountBooklet2.indd 3 10/5/10 4:00 PM