Installation Instructions

handset memory, the data indicator would be steady on at the time.
After all the data is uploaded, the data indicator will be off.
Group Working of Multi-bases
In case two or more bases are working in the same room, please set
them to different channels to ensure high uploading efficiency.
1. Press ③Channel Button to set the channel number (the channel
number could be displayed on a Notepad by Windows OS during the
operation, just like the barcode data).
2. Re-pair the handset to the base to activate the new channel.
Tip: In case two or more bases (groups) are working in the same signal
channel, the uploading speed could be slow down. However, the data
uploading won’t mixed up.
Work in High Humidity and Wet Environment
The handset can work in a high humidity environment and can also
resist short-term shallow water immersion. But the base MUST NOT be
soaked in water or work in a condensed water environment.
Note: After replacing the battery, please make sure the battery cover is
properly installed, so as not to affect the waterproof performance.
Wall Mounting
This scanner can be wall mounted. To make wall mounting, remove
the flat buckle on the base and replace it with the ⑨Wall Hanging
Buckle. Please refer to the wall buckle accessories for more details.
Common Settings
Information Check
Firmware Version
Handset Serial No.
Base Version
Base Serial No.
Suffix Quick Setup
CR (Default)）
LF
CR+LF
No Suffix
Common Symbol Setting
Support all
Only 1D
Only 2D
Setting the Torch
Torch on when scanning
Always On
Torch off
Auxiliary mode 1
Auxiliary mode2
Auxiliary mode2
Aiming Line Setting
Be on in Scanning
Always on
Off
Setting the Data Upload Mode
No Storing Mode: Every code data will be uploaded instantly to the
base once well captured. In case of unsuccessful upload (the handset is
out of connection or the base was not well connected to PC), the code
data will be abandoned and alarm of “Dee-Dee-Dee” will come out.
Auto Storage Mode (Default): The data will be stored in the handset
memory in case of failure of uploading to base. And the data will be
uploaded to base once the contact connection come back normal. It’s
the default working mode.
Manual Mode: The code data will firstly be stored in the built-in
handset memory once well captured, it can store up to 55,000pcs codes.
The data would be uploaded to base and then to the PC when “Upload
Start” is scanned. If you don’t erase the storage, the data will always
exist.
Auto Storing
(Default)
No Storing
Manual Mode
Upload Start
Erase Storage
Wireless Communication Power setting
High (14dBm)
Low (0dBm)
Tips: Please set the wireless communication power according to the
relevant local regulations (you can consult the local authority of the
radio management).
Prefix
Transmit Prefix
On
No Prefix (Default)
Start Setting Prefix
Suffix
Transmit Suffix On
No Suffix (Default)
Start Setting Suffix
The steps for setting the Prefix (Suffix) are as follows:
1. Scan "Start Setting xxx";
2. Scan the ASCII value of the hexadecimal parameter barcode of
the string (2 digits per character); for example, the parameter of
character “A” is "41", and the parameter of “B” is “42”.
3. Scan "Finish Setting".
4. Scan "Transmit Prefix" ("Transmit suffix ")
Parameter Bar code
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Finish Setting