Installation Guide
Table Of Contents
«TICA PRO» LLC Tel.: +7 495 127 79 00, +7 969 190 85 85 E-mail:
info@tica.pro
Application Form for Debugging Inverter VRF Air Conditioning Unit (Filled by Installer)
Full name of the installer:___________________________________________________________
Address of the installer:____________________________________________________________
Owner's name or employer:_________________________________________________________
Person to contact:_______________________________Tel:______________________________
Installation site:_________ Province _________ City ____________________________________
Unit model: ___________________________
IDU bar code:___________________________
ODU bar code:___________________________
Distributor:________________________ Person to contact:_________________________
Tel:______________________________ Fax:____________________________________
Installer:__________________________ Person to contact:_________________________
Tel:______________________________ Fax:____________________________________
The following items are to be filled by the installer correctly and faxed to TICA Factory 400 Center 48 hours
before boot debugging, so that the debugging can be arranged in due time.
Tel.: +7 495 127 79 00, +7 969 190 85 85
In case the form contents are different from the real situation, causing the experts unlikely to conduct
debugging on site, the installer must be liable for labor and travelling expenses incurred to the debugging
experts.
Contents to be Checked and Confirmed by Installer
Before installation, ask the installer to carefully read through the manuals and relevant requirements
attached to the unit.
1. Check installation position
a. Whether heat dissipation and ventilation for ODU meets requirements for distance
Yes ( ) No ( )
b.
Whether ODU is installed on a base firmly and with vibration damping measures
applied
Yes ( ) No ( )
c. Whether IDU is provided with vibration damping measures and properly fastened Yes ( ) No ( )
d. Whether there is space for maintenance Yes ( ) No ( )
2. Check electrical system before installation
Yes ( ) No ( )
a. Whether air switch capacity and power wire diameter meet unit requirements Yes ( ) No ( )
b. Whether correctly wired and whether wiring terminal is pressed
and completely
connected
Yes ( ) No ( )
c.
Whether neutral line and grounding wire are connected in accordance with
electrical codes
Yes ( ) No ( )
d. Whether the distribution of control wire and power wire meets anti-
interference
requirements
Yes ( ) No ( )
e. Whether the length of control wire and power wire is proper Yes ( ) No ( )
3. Check refrigerating system before installation
Yes ( ) No ( )
a.
Whether refrigerant duct meets factory requirements in terms of its diameter and
thickness
Yes ( ) No ( )
b. Whether the length of refrigerant duct meets relevant requirements Yes ( ) No ( )
c. Whether added nitrogen for welding refrigerant duct to protect air conditioning unit
Yes ( ) No ( )
d. Whether cleaned refrigerant duct Yes ( ) No ( )
e. Whether used nitrogen for holding pressure to test leakage Yes ( ) No ( )
f. Whether vacuumized refrigerating system against installation manual Yes ( ) No ( )
g. Whether supplemented refrigerant according to standard Yes ( ) No ( )