User Manual

T4.1MANUAL 13
CLEANING
Never perform maintenance on a loaded or pressurized T4.1 marker.
Remove all projectiles and CO2 cartridges from the magazine and marker prior to doing any
cleaning or maintenance.
Never use petroleum based cleaning solvents or lubricants.
Do not use cleaning solvents that come in aerosol cans.
To clean the T4.1 marker, remove the barrel as described in the “Operational Instructions”.
Use a .68 caliber soft nylon brush or 12 gauge patch tip with a soft cotton cloth to clean the barrel.
Do not place lubricant or water in the barrel of the T4.1. It is designed to be used with the barrel completely dry.
Keep the barrel of the T4.1 dry.
Wipe o any dirt or grime from the outside of the T4.1 with a dry cloth.
OILING THE MARKER
IMPORTANT: Before performing any of the following instructions, remove magazine. Point marker
in safe direction and discharge until degassed.
For optimum performance, do the following monthly:
1. Place one drop of oil between trigger release and trigger rotator.
(See Page 28)
2. Remove the regulator spring pad (See page 29) and oil the regulator
spring pad O-Ring.
3. Remove the engine assembly (See page 17) and lightly grease the
AC Cap O-Ring.
4. Place one drop of oil on CO2 O-Ring found at top of CO2 Valve
and Magazine (See page 21).
OPERATIONAL CONSIDERATIONS
If the CO2 cartridge is punctured in a magazine, it should be replaced if the T4.1 is not used for 24 hours.
The operational temperature range for the T4.1 marker is 37° F to 120°F.
T4.1 CLEANING & MAINTENANCE