User Manual

T4.1MANUAL6
3. REMOVING THE BARREL - (1) Shut o the slide check attached to the tank. (2) Next, remove the magazine
from the marker. (3) Slightly push in the barrel and rotate the barrel lock counterclockwise. Then pull down
the barrel lock. (4) Your barrel is now free to slide out along the barrel lock track.
3
3
4
2
1
HOPPER ATTACHMENT
1. REMOVE HOPPER COVER PLATE - Remove the Hopper Cover Plate by removing the four (4) Cover Plate
Screws, (Top two screws H-S 440 3/4, Bottom two screws H-S 440 3/8) by using a 3/32 Allen Wrench.
2. ROTATE BARREL - To rotate the barrel pull back on the charging handle located on the rear of the gun
above the stock until it locks in the rear position. Leave in this position to shoot using a hopper
3. BARREL RELEASE - Press the release button located on the left side of the marker to switch back to
magazine mode.
4. ATTACH HOPPER ELBOW - Attach the Hopper Elbow located in the universal pack that came with the
rie using the four (4) Hopper Screws, also located in the universal pack. These screws require a 3/32 Allen
Wrench.