User's Manual
Table Of Contents
- I.General
- II.Features
- 1. Adopting 470MHz wireless communication technolo
- 2. With battery low-voltage detection function, it
- 3. Use microprocessor to realize signal processing
- III.Technical specifications
- IV.Structure characteristics and working principle
- When the module input terminal receives the closin
- When the module receives the control signal from t
- When the module battery is low, the module sends a
- 3.Installation method
- V.Test
- Warning: Please make sure that the polarity of the
- 1. After the module is installed and tested every
- 2. Alarm test: After the networking is successful,
- 3. During the test, the unqualified modules are re
- VI. Use and operation
- VII. General failure and repair
- VIII. Notes
- 1. After the signal passes through the wall, the s
- 2. When installing the product, keep it away from
- 3. Install in a low-interference environment and f
JTY-GM-TC5401W 无线点型光电感烟火灾探测器安装使用说明书 Ver1.0 202010
辽宁•营口天成消防设备有限公司
4
When the module input terminal receives the closing signal, it sends an alarm signal to the control panel
through wireless communication technology, and the module input indicates that the red light is always
on.
When the module receives the control signal from the control panel, the module outputs a closing signal
to connect to other devices, and the module output red light is always on.
When the module battery is low, the module sends a battery undervoltage signal to the control panel,
and the fault yellow light flashes.
3.Installation method
1. Before installation, first check whether the shell is intact and whether the identification is complete.
2. Module fixing method:
When installing, use two screws to fix the module base on the 86 series (width 72mm, height 49mm,
depth 47mm) embedded box, and then install the button front panel, the installation hole distance is
60mm.
Fig.2 Installation method