User's Manual
Table Of Contents
- I.General
- II.Features
- 1. Adopting 470MHz wireless communication technolo
- 2. With battery low-voltage detection function, it
- 3. Use microprocessor to realize signal processing
- III.Technical specifications
- IV.Structure characteristics and working principle
- When the module input terminal receives the closin
- When the module receives the control signal from t
- When the module battery is low, the module sends a
- 3.Installation method
- V.Test
- Warning: Please make sure that the polarity of the
- 1. After the module is installed and tested every
- 2. Alarm test: After the networking is successful,
- 3. During the test, the unqualified modules are re
- VI. Use and operation
- VII. General failure and repair
- VIII. Notes
- 1. After the signal passes through the wall, the s
- 2. When installing the product, keep it away from
- 3. Install in a low-interference environment and f
JTY-GM-TC5401W 无线点型光电感烟火灾探测器安装使用说明书 Ver1.0 202010
辽宁•营口天成消防设备有限公司
3
9. Reset method: by control panel
10. Application environment：
Type：indoor Atmosphere pressure：86kPa～106kPa
Temperature：-10℃～+55℃ Relative humidity≤95%，non-condensing
11. Outline dimension：101mm×137mm×43mm
12. Material and color：ABS, off-white
13. Weight：about 170g (including battery)
14. Executive standard：GB 16806-2006 "Fire Linkage Control System"
XF 1151-2014 "General Requirements for Wireless Communication Functions of Fire
Alarm Systems"
IV. Structure characteristics and working principle
1. The outline diagram of the module is shown in Figure 1 ：
Figure 1 Outline diagram of the module
2. Working principle