Installation Manual

J- SAP -TC SB5406W Wireless Digital Manual Call Point
Installation making use instructions Ver1.1 202011
YINGKOU TIANCHENG FIRE PROTECTION EQUIPMENT CO., LTD
3
Figure 1 Schematic diagram of the appearance of the alarm button
4.2. working principle
This alarm button uses pressing the alarm mode, the alarm signal is triggered switch is
pressed , the alarm button red normally lit , an alarm signal through the
wireless communication transmission scheme to a control panel in response to the alarm signal an
alarm . When the alarm button battery power is low, alarm button transmits the battery voltage signal to
the control panel by wireless , and failure light every 48 flashes second two times .
5.Installation Method
5.1 . Before installation should first check whether the shell intact, identification is complete.
5.2 . Alarm button fixed manner :
When installed , using two screws alarm button base fixed to the series 86 (72mm wide, 49mm
high, 47mm deep) on the embedded box, and then installed to the front panel button, as the installation
pitch . 6 0 mm .
Figure 2 Installation method