Installation Manual

J- SAP -TC SB5406W Wireless Digital Manual Call Point
Installation making use instructions Ver1.1 202011
2.Features
2.1 using the pressing structure design, alarm button press need to use special tools to reset ;
YINGKOU TIANCHENG FIRE PROTECTION EQUIPMENT CO., LTD
1
1.Overview
J-SAP-TCSB5406 W Wireless Digital Manual Call Point (hereinafter referred to as the
alarm button ) is suitable for installation in public places, factories and other environments. When a fire
is manually confirmed, press the button on the MCP, and the red light of the MCP is always on. to the
wireless communication technology transmits an alarm signal to the control panel, the control panel
when the response should the alarm signal the alarm button enters a wait control panel reset state, an
alarm button while the control panel displays the encoded information and an alarm sounds.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on,the user is encouraged to try to correct
the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Important: You are cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.