User's Manual
Table Of Contents
- I. General
- II. Main Characteristics
- III. Technical Specifications
- IV. Structure and Working Principle
- 1. Points for on-site installation
- The wireless performance indicators of this produc
- VI. Test
- 1. The detector must be tested after installation
- 2. Simulated fire alarm: After the networking is s
- 3. In the process of testing, the unqualified dete
- VII. Use and Operation
- 1.Network segment setting: Before the detector con
- 2. Device enters and exits the network: After the
- A) Network access: When the control panel is in th
- B) Network exit operation: When the control panel
- 3. Equipment alarm:
- When the smoke concentration in the environment re
- 4. Device reset: When the device reports a fire al
- 5. Restore factory settings: After the detector is
- Note: The button function only has one click, thre
- VIII.General Fault and Solutions
- IX. Maintenance
JTY-GM-TC5401WWireless Addressable Photoelectric Smoke Detector User Manual Ver1.0 202010
Yingkou Tiancheng Fire Protection Equipment Co., LTD
3
Figure 1 Schematic diagram of the shape of the detector
2. Working principle
The detector uses an infrared photoelectric pair tube as the sensor. The output signal of the sensor is input to the
single-chip microcomputer after voltage conversion, and the single-chip uses an intelligent algorithm to process the signal.
When the detected smoke concentration reaches the alarm value, the red light of the detector will be on, and the alarm
signal will be sent to the control panel in wireless way, and the control panel will respond to the alarm signal; in this
process, the detector is waiting for the control panel to reset; if the control panel has never responded to the fire alarm
signal,the detector sends a fire alarm to the control panel again every ten minutes; when the detector battery is
under-voltage, the yellow light flashes once every 48s.
When the smoke chamber is polluted, the yellow light of the detector is always on, and a fault signal is sent to the control
panel in wireless way. After the control panel responds to the fault signal, the detector is in a state of waiting for the
control panel to reset during this process; if the control panel is always not responding to the smoke chamber pollution
signal, the detector sends a fault signal to the control panel again every ten minutes.
V. Installation
Note: Before installing the detector, please make sure that the battery polarity is correct and the detector base is firmly
installed.
1. Installation method
The schematic diagram of the detector installation is shown in Figure 2.
Fig.2 Schematic diagram of the detector installation
The schematic diagram of the base of the detector is shown in Figure 3. Fix the base with two self-tapping screws or stick it
firmly with 3M glue. After the base is firmly installed, align the bottom of the detector and rotate the base clockwise to
install the detector on the base.