Installation Instructions

relationship on the bus panel. After setting, press the "Cancel" key to exit the setting.
When the linkage module is connected to the local machine, fill in 000, and when the
linkage module is connected to other machines, fill in the number of the control panel
where the module is located.
5.4.3 Definition example of direct control panel
Enter "System Settings" → "3. Direct control panel Settings".
Figure 5-5
Enter the key number of the direct control panel and the corresponding setting
information. Then press the corresponding "Enter" key to set the dedicated line panel.
After setting, press the "Cancel" key to exit the setting.
The "key number" corresponds to the key number of the dedicated line starting
operation on the dedicated line display panel.
The "secondary code" consists of eight digits from 0 to 9, which is a group of
numbers defined artificially to express the specific on-site environment where the
equipment is located. Users can easily know the location of the coded equipment and
other information related to the location through this code. The user code is specified
as follows:
"Mode" can be set to "Continuous" and "Inching", which are represented by 0 and 1
respectively.
"Inspection line" can be set as "inspection line" and "inspection line", which are
represented by 0 and 1 respectively.
"Annotation information" means the location of the equipment or other relevant
Chinese character prompt information. This item can be composed of 10 Chinese
characters or 20 characters at most, or the combination of Chinese characters and
characters can not exceed 20 characters in length.
5.4.4 Wireless access to the Internet
Before wireless registration, please enter "Network Settings" → "2. Wireless Settings",
and set the wireless parameters first. If there are multiple wireless hosts, it is
recommended to set the wireless network segments at intervals of 5 network segments.