Installation Instructions

stopped state.
4.9 Automatic linkage control of bus controlled equipment
4.9.1 Conditions for realizing automatic linkage
Only when the control panel is in the state of "automatic permission", can the
automatic linkage start command be issued.
When someone is on duty, the bus equipment should be started manually as much as
possible.
4.9.2 Implementation of Automatic Linkage Logic
When the logical relationship in the linkage formula is satisfied, the control panel will
automatically issue a start command to start the corresponding equipment. See 5.4
editing method of automatic linkage formula for specific programming method.
4.10 Reset function
After the fire alarm or fault is handled, clear the control panel by pressing the "Reset"
key and entering the user password. Reset can achieve the following functions:
Clear all current fire alarm, fault and action displays.
Reset the status indicator lights on all bus controlled equipment and manual fire
startup disk.
Clear the command that is in the process of requesting and delaying the start of the
request.
Clear the mute state.
5. System administrator's guide
Chapter 5 System administrator's guide
5.1 Modify time
Press the "Menu" key to enter "4. User Settings" → "1. Date and Time", and the
screen shown in Figure 5-1 will appear. After editing and modifying, the new system
time is obtained by saving the modified contents after confirmation.
Figure 5-1
5.2 Print mode setting