Installation Instructions

control panel is in the key locking state, enter the user password to unlock it), and the
screen display is shown in Figure 4-11 and Figure 4-12.
Enter the circuit and address of the equipment to be started or stopped.
Press the "Confirm" key, and the control panel issues a command to start or stop the
equipment.
Figure 4-11
Figure 4-12
4.8.3 Manual start/stop operation of controlled equipment by bus control panel
To start a controlled bus device, first find the unit corresponding to the device to be
started according to the prompt information in the transparent window of the bus
control panel, press the manual key of this unit, the command light will light up, the
start command will be issued and the device has been started; If this key is pressed
again, the indicator will be ordered to go out, the equipment will stop and return to the