User's Manual

2.2 The operation of keys

There is a power key in the receiver, the operations are as follows.

Power key

The main function of power key is power on/off and confirm button.

 Power on: when the Receiver is in the OFF status (no light), press the power key,

and then the receiver will enter the initialization status. Then you will listen beep

for three times and the voice broadcast the current receiver status, it means the

receiver powered on successful.

 Power off: when the G6 receiver is in the ON status (power supply light ON),

press and hold power key for few seconds until all lights blink, then release the

power key and there will be a voice broadcast “If you want to turn off the device”.

Press the power key to confirm, then G6 will be turned off.

2.3 Self-checking

If the indicators are abnormal or the receiver can’t work normally, for example the

Bluetooth can’t be connected, the radio mode can’t work, it can’t connect to the

CORS. Then you can use the automatic detection function, which is Receiver

self-checking. Self-checking will check GPS, radio, GSM, Bluetooth, WIFI and sensor.

During this procession, it has voice guide tell you whether it’s normal or not.

1. When the receiver is in powered on status, keep press the power key until a

voice broadcast “if you want to turn off the device”, then release the power key.

Keep press the power key again until you hear a beep, then there will be voice

broadcast “start self-checking” and you could release the power key (The new

device should be self-checked once).

2. In the process of device self-checking, there will be voice broadcast the test

results. If the module checking is successful, voice broadcast “success” and the

led always on until the self-checking is completed. If the module checking fails,

voice broadcast “self-checking fails”, the led will continue blink and the buzzer

beeps until you restart G6. Self-checking procedure lasts about 1 minute.