User's Manual
Page |
21
4. Factory AsteRx2e receiver Settings
The instructions below should be used to reconfigure an G3100 back to PENTAX
Default. This is the #1 method for resolving problems with the G3100โs operation, and
should always be executed before contacting PENTAX support.
Reconfiguring the G3100 back to PENTAX Default sets the unit as a Rover,
Message Type: RTCM v3.1, Logged Data Type: SBF. The two ways of accomplishing
factory settings are:
1) Upload appropriate
[1]
PENTAX default script using RxControl
2) Typing the commands in line-by-line.
[1]
The G3100 model is determined by the serial number found on the bottom of
the receiver.
4.1. Uploading a script/text file using RxControl
A text file with factory reset commands is included on the CD shipped with each new
G3100 unit. The file can also be downloaded from the PENTAX website:
ยง
G3100 (2XXXX):
G3100 Default Config.txt
4.1.1. From the RxControl File menu, select โUpload scriptโ.
Figure 10: Upload Script