User's Manual

Page |
13
2.1.10.2. Installing SIM Card
Turn Off
G3100
to install or remove SIM card. Damage to SIM card may occur if
installed or ejected with power ON.
To Install/Remove SIM Card:
· Unlock SIM & SD Card compartment by turning lock groove horizontal
· Open SIM & SD Card compartment
· Push the yellow SIM Card holder eject button to release SIM Holder
· Pull out SIM Holder
· Place SIM Card in SIM Card Holder
· Hold the SIM Card in holder upside down
· Using the guide, slide SIM Card Holder in the slot. The eject button will pop out.
2.1.11. SD Card
The G3100 comes pre-installed with a 2GB SD Card for internal data logging. When using with
G3100 for data logging, it will record data in SBF (Septentrio Binary Format), which can be converted into
RINEX format for Post Processing.
Handle
the
SD
Card
with
care.
When
not
in
use,
leave
it
inside
the
G3100
or
place
it
in SD Card Holder for transportation or storage.
A 2GB SD Card has capacity of ~8.8 days at 1Hz data rate. Memory is used at 9.4 MB/hr when
logging default data at 1Hz.
File Information:
Format: Septentrio Binary Format (SBF)
Size: Up to 72kB per second
Turn OFF the G3100 to install or remove SD card. Data loss an
d corruption may
occur if SD Card is removed while G3100 is ON.
2.1.11.1. Removing SD Card
· Unlock SIM & SD Card compartment on the back of the G3100
· Open SIM & SD Card compartment
· Push SD Card to release locking mechanism
· Pull SD Card out of the slot
2.1.11.2. Installing SD Card
· Unlock SIM & SD Card compartment on the back of the G3100
· Open SIM & SD Card compartment
· Insert SD Card using the guide
· Push SD Card into the slot until it locks into place