User Manual

Page |

2.1.12. Connecting USB cable

Connect Dsub 9pin connector of “Data cable of updating firmware and transferring data for

G2100”to the PC. (A USB/Serial adapter may be required if the PC does not have a DB9 COM port.) The

power of receiver is not reqired to turn ON when the USB connector (7-pin LEMO) is connected to the

receiver. Then connect LEMO 7 pin connector to the COM1 port of G2100B/R receiver in the right

direction.

2.1.13. Download data from internal memory

Any special driver is not required. After the connection, the receiver will be recognized

and then data in the internal memory can be copied to your PC.

2.1.14. Connection for uploading the firmware.

Connect Dsub 9pin connector of “Data cable of updating firmware and transferring data for

G2100”to the PC. For more detail of updating firmware, please refre the service information for

corresponding firmware.

A USB/Serial adapter may be required if the PC does not have a DB9 COM port.

*Some USB/Serial adapters are not compatible with the G2100.

USB/Serial adapters with prolific drivers are preferred.*