User Manual

Page |
10
Orange
ON: Receiver is Powered ON
OFF: Receiver is Powered OFF
ON:External Radio ON:RTK Rover
Green
Blinks 1 time , then pauses : 1
Satellites
Blinks 2 times, then pauses : 2
Satellites
Blinks n times, then pauses : n
Satellites
N/A
ON: Internal Radio
This is used for
changing Frequency
of radio etc..
Red
ON(Flashing): Writing data on the
internal memory.
It blinks 1 time for 512Byte data.
ON:Bluetooth ON
This is used for
changing Bluetooth
ID.
All LED ON:No meaning
2.1.7. Power Button and Start up procedure
The power button is located on the front panel, and has the primary function for turning the G2100 ON
or OFF. Follwings are description of start up sequence and how to select device in the connection mode.
1. PWR On: 5 LED will turn ON
2. Firmware initialization will start(takes around 10sec.)
3. PWR LED will be ON
4. Receiver will search satellites: STA LED will be ON
After pressing “Fn” keyfor 3sec;
5. One of LED among BT(GSM), RTK(Int radio) and PWR(Ext. radio) will be ON
6. Selection can be chaged by pressing Fn key
7. Pressing PWR key can re-start the initialization
Power Button
What to do in the “Normal mode”.
Power ON
Press and release, RED LED turns ON
Power OFF
Press and hold for 5 seconds and release or until power LED turns OFF
What to do in the “Connection mode”.
Confirm the
selection
Press to confirm the selection among STATIC, RTK Base and RTK
Rover.
Change the
selection
Press to change the selection.
What to do in the “Setting mode”.
Confirm the
selection
Press to confirm the selection.
Change the
selection
Press to change the selection.