Users Manual
Table Of Contents
- 2Functional Overview
- 3Interfaces Description
- 3.1Interfaces Parameter Definitions
- 3.2Interfaces Detail Description
- 3.2.1Power Supply Interface
- 3.2.2Touchscreen Interface
- 3.2.3Display Interface
- 3.2.4Camera Interfaces
- 3.2.5Audio Interface
- 3.2.6USB & DisplayPort Interface
- 3.2.7 PCIe Interface
- 3.2.8 SSC Interface
- 3.2.9 SDIO Interface
- 3.2.10 QUP Interface
- 3.2.11Power on Interface
- 3.2.12Reset Interface
- 3.2.13 Keys Interface
- 3.2.14 Sensor Interrupt Interface
- 3.2.15Debug UART Interface
- 3.2.16Battery Interface
- 3.2.17ADCs Interface
- 3.2.18 PWMs and LED Current Driver Interface
- 3.2.19Antenna Interface
- 4Connector PIN Summary
- 5Electrical Characteristics
Thundercomm TurboX D845 System on Module
Copyright © 2018 All Rights Reserved , Thundercomm Technology Co., Ltd.
15
3 Interfaces Description
This chapter introduces all the interfaces definition, purpose to guide developer easy to design and
verification on Thundercomm TurboX
TM
D845 SOM.
3.1 Interfaces Parameter Definitions
Symbol Description
AI Analog input
AO Analog output
B Bidirectional digital with CMOS input
CSI Supply voltage for MIPI_CSI circuits and I/O; (1.8 V only)
DI Digital input(CMOS)
DSI Supply voltage for MIPI_DSI I/O; (1.8 V only)
DO Digital output(CMOS)
H High-voltage tolerant
nppdpukp
Programmable pull resistor. The default pull direction is indicated using capital letters
and is a prefix to other programmable options:
NP: pdpukp = default no-pull with programmable options following the colon (:)
PD: nppukp = default pull-down with programmable options following the colon (:)
PU: nppdkp = default pull-up with programmable options following the colon (:)
KP: nppdpu = default keeper with programmable options following the colon (:)
KP Contains an internal weak keeper device (keepers cannot drive external buses)
MIPI Mobile industry processor interface
NP Contains no internal pull
OD Open drain
PD Contains an internal pull-down device
PI Power input
PO Power output