Users Manual Part 2

Thundercomm TurboX C865 System on Module
Copyright © 2018 All Rights Reserved, Thundercomm Technology Co., Ltd.
2
I2C is a two-wire bus that can be routed to multiple devices; each line of each bus need to supplement by a
2.2kΩ pull-up resistor
QUP Interface
PIN Name
Location
PIN
Voltage
Type
Description
Notes
GPIO0 CON1 K32
P3
IO
QUP19 can be
configured to GPIO or
UART or SPI or I2C
GPIO1 CON1 E39
P3
IO
GPIO2 CON1 F38
P3
IO
GPIO3 CON1 E38
P3
IO
GPIO4 CON1 H33
P3
IO
QUP1 can be configured
to GPIO or UART or SPI
or I2C
GPIO5 CON1 H31
P3
IO
GPIO6 CON1 H30
P3
IO
GPIO7 CON1 H32
P3
IO
GPIO12 CON1 B9
P3
IO
QUP5 can be configured
to GPIO or SPI or I2C
GPIO13 CON1 B10
P3
IO
GPIO14 CON1 J27
P3
IO
GPIO15 CON1 J28
P3
IO
GPIO24 CON1 G32
P3
IO
QUP8 can be configured
to GPIO or UART or I3C
or SPI or I2C
GPIO25 CON1 J36
P3
IO
GPIO26 CON1 K36
P3
IO
SDM_FAST_BOOT_0 CON1 B47
P3
IO GPIO27
GPIO28 CON1 H29
P3
IO
QUP0 can be configured
to GPIO or UART or I3C
or SPI or I2C
GPIO29 CON1 H28
P3
IO
GPIO30 CON1 H27
P3
IO
GPIO31 CON1 H26
P3
IO
TS_I2C_SDA CON1 E42
P3
IO
QUP13 can be configured
to GPIO or SPI or I2C
GPIO36
TS_I2C_SCL CON1 D41
P3
IO GPIO37
TS_RESET_N CON1 D42
P3
IO GPIO38
TS_INT_N CON1 D40
P3
IO GPIO39
FP_SPI_MISO CON1 C37
P3
IO
QUP14 can be
configured to GPIO or
UART or I3C or SPI or
I2C
GPIO40
FP_SPI_MOSI CON1 B37
P3
IO GPIO41
FP_SPI_CLK CON1 B36
P3
IO GPIO42
FP_SPI_CS CON1 C36
P3
IO GPIO43
APPS_I2C_SDA CON1 F44
P3
IO
QUP15 can be
configured to GPIO or
SPI or I2C
GPIO44
APPS_I2C_SCL CON1 E43
P3
IO GPIO45
MIPI_ERR_FG CON1 E41
P3
IO GPIO46
SDM_FAST_BOOT_1 CON1 E40
P3
IO GPIO47
GPIO52 CON1 G36
P3
IO
QUP17 can be