Users Manual

Table Of Contents

Thundercomm TurboX C865 System on Module

RF Exposure Information

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This device is intended only for OEM integrators under the following conditions:

1. The antenna must be installed such that 20cm is maintained between the antenna and users, and

2. The transmitter module may not be co-located with any other transmitter or antenna.

The PIFA antenna has been approved for the modular. The maximum antenna gain is 2dBi. For situations where the

host manufacturer is responsible for an external connector, the integration instructions shall inform the installer that

a unique antenna connector must be used on the Part 15 authorized transmitters used in the host product.

Important Note: In the event that these conditions cannot be met (for example certain laptop configurations or

co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID

cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for

re-evaluating the end product (including the transmitter) andobtaining a separate FCC authorization.

Any company of the host device which install this modular with limit modular approval should perform the test of

radiated emission and spurious emission according to FCC part 15C:15.247, 15.407 and 15.209 requirement, only

if the test result comply with FCC part 15.247, 15.407 and 15.209 requirement, then the host can be sold legally.

End Product Labeling

If the FCC identification number is not visible when the module is installed inside another device, then the outside

of the device into which the module is installed must also display a label referring to the enclosed module. This

exterior label can use wording such as the following: Contains Transmitter Module FCC ID:

2AOHHTURBOXC865.

Manual Information to the End User

The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove

this RF module in the user’s manual of the end product which integrates this module.

The end user manual shall include all required regulatory information/warning as show in this manual.

The modular is not intended to be fielded serviceable as without shielding, host manufacturer must be considered