Users Manual
Table Of Contents
- 1 Physical Description
- Interfaces Description
- Interfaces Parameter Definitions
- Interfaces Detail Description
- Power Supply Interface
- Touchscreen Interface
- Display Interface
- Camera Interfaces
- Audio Interface
- USB & DisplayPort Interface
- PCIe Interface
- SSC Interface
- SDIO Interface
- QUP Interface
- Power on Interface
- Reset Interface
- Keys Interface
- Sensor Interrupt Interface
- Debug UART Interface
- Battery Interface
- ADCs Interface
- PWMs and LED Current Driver Interface
- Antenna Interface
- Connector PIN Summary
- Electrical Characteristics
Thundercomm TurboX C865 System on Module
Copyright © 2018 All Rights Reserved, Thundercomm Technology Co., Ltd.
36
J24 PCIE2_TX0_P_MDM PCIe 2 Gen 3 transmit 0 - plus
J25 PCIE2_TX1_M_MDM PCIe 2 Gen 3 transmit 1 - minus
J26 CABC CABC
J27 GPIO_14 GPIO 14
J28 GPIO_15 GPIO 15
J29 ALPS_INT_N interrupter
J30 EYETCK_2V8_EN GPIO 114
J31 CAM3_RST_N Camera 3 reset, GPIO109
J32 SEN1_GYRO_INT2 Sensor Interrupt, GPIO 113
J33 SEN1_ACCL_INT1 Sensor Interrupt, GPIO 112
J34 TE TE for LCM, GPIO 67
J35 CCI_I2C_SDA3 Dedicated camera control interface I2C 3 serial data
J36 GPIO_25 GPIO 25
J37 SNS_I2C0_SDA Data of I2C0, for sensor
J38 SPI2_CLK_IMU SPI clock, for sensor
J39 SPI2_CS_IMU SPI selection, for sensor
J40 SPI2_MISO_IMU SPI MISO, for sensor
J41 SPI2_MOSI_IMU SPI MOSI, for sensor
J42 GPIO_87 GPIO 87
J43 DMIC23_CLK DMIC2/3 clock
J44 DMIC23_DATA DMIC2/3 data
J45 DMIC45_CLK DMIC4/5 clock
J46 DMIC45_DATA DMIC4/5 data
J47 VBAT_CON VBAT
J48 VBAT_CON VBAT
J49 VBAT_CON VBAT
J50 VBAT_CON VBAT
K1 NC NC
K2 NC NC
K3 NC NC
K4 NC NC
K5 NC NC
K6 NC NC
K7 NC NC
K8 NC NC
K9 NC NC
K10 NC NC
K11 GND GND
K12 CSI0_C0_LN0_M MIPI CSI 0 (DPHY), differential lane 0 – minus
K13 GND GND
K14 CSI0_C2_LN3_M MIPI CSI 0 (DPHY), differential lane 3 – minus
K15 GND GND
K16 DSI0_A0_LN0_P MIPI DSI 0 (DPHY), differential lane 0 – plus