Users Manual
Table Of Contents
- 1 Physical Description
- Interfaces Description
- Interfaces Parameter Definitions
- Interfaces Detail Description
- Power Supply Interface
- Touchscreen Interface
- Display Interface
- Camera Interfaces
- Audio Interface
- USB & DisplayPort Interface
- PCIe Interface
- SSC Interface
- SDIO Interface
- QUP Interface
- Power on Interface
- Reset Interface
- Keys Interface
- Sensor Interrupt Interface
- Debug UART Interface
- Battery Interface
- ADCs Interface
- PWMs and LED Current Driver Interface
- Antenna Interface
- Connector PIN Summary
- Electrical Characteristics
Thundercomm TurboX C865 System on Module
Copyright © 2018 All Rights Reserved, Thundercomm Technology Co., Ltd.
11
PD Contains an internal pull-down device
PU Contains an internal pull-up device
P3 Power group 3, it is 1.8V.
P2 SDC Power group 2, it is 1.8V or 2.95V.
Table 2.1-1 Interfaces parameter definitions
2.2 Interfaces Detail Description
2.2.1 Power Supply Interface
Below table describes all interfaces of SOM Power Supply. For the detail parameter request, please refer the
chapter on Electrical specifications.
Power Supply
PIN Name Conn. PIN Type
Description,
V_typ@I_rated
Note
VBAT_CON CON1
J47,J48,J49,J50,K47,K48,K
49,K50
PI Power supply input for SOM
USB_VBUS CON1 E47,E48,E49,E50 PO
USB output during
USB-OTG operation.
VREG_L11C_3P3 CON1 A49 PO LDO, 3.1V@600mA
VREG_L9C_2P96 CON1 A50 PO LDO, 2.96V@600mA
VREG_L5C_1P8 CON1 B4, B5 PO LDO, 1.8V@150mA
VREG_L8C_1P8 CON1 B42 PO LDO, 1.8V@150mA
VREG_IO_1P8 CON1 B44 PO
VREG SPMI output for
SPMI PAD and PX0
VREG_L2A_3P1 CON1 D43 PO LDO, 3.1V@150mA
VREG_S4A_1P8 CON1 D45, D46 PO BUCK, 1.8V@3500mA
VREG_BOB CON1 D47, D48 PO Buck-boost output, 3.3V
VPH_PWR CON1 D49, D50 PO Primary system supply node
GND CON1
A1,A3,A5,A12,A14,A16,A
18,A20,A22,A24,A26,A28,
A30,A32,A34,A36,B2,B3,
B48,B49,B50,C1,C3,C11,C
13,C15,C17,C19,C21,C23,
C25,C27,C29,C31,C33,C35
,C4,C48,C49,C50,D2,D4,D
12,D14,D16,D18,D20,D22,
GND GND