Data Sheet

TurboX C610 SOM DATASHEET
Copyright© 2020 Thundercomm Technology Co., Ltd. All rights reserved.
20
If held at a logic low for longer durations. Can also be configured for generating a stage
2 and/or stage 3 reset Pulled up internally to 1.8V via the dVdd regulator.
 CBL_PWR_N:
Alternate input pad, which can be used to initiate the power-on sequence when
grounded; pulled up internally to 1.8V via the dVdd regulator.
3.6 C610 Boot Configuration
Special boot-related GPIO features:
 They are sensed for boot-purposes during IC reset (during fuse sense).
 After boot-up, use them for normal GPIO functions.
 Do not have pull-ups on Boot configuration GPIO
Forced USB boot:
During development or factory production, boot from USB3.1 port are forced by using
GPIO_101.
 FORCED_USB_BOOT (GPIO_101) always takes precedence, regardless of the state of
the BOOT_CONFIG GPIOs or FAST_BOOT_SEL fuses.
 FORCED_USB_BOOT is checked first during the boot device detection prior to
BOOT_CONFIG GPIOs.
 GPIO_101 = 1 forces the SDM device to boot from USB0 port.
3.7 C610 USB Ports
QCS610 has two USB ports
 USB port 0 – 4-lane USB3 PHY and USB2 PHY connected to USB3 controller
 USB port 1 – USB2 PHY connected to USB2 controller and 4-lane DisplayPort
connected to DP controller Over USB3 PHY.
During Development or factory production, we can download images to memory using
USB port 0.
Please note the usage of TYPEC_uUSB_SEL.
C610 SOM
GPIO_101
VREG_1.8 V