Manualshelf

Product Manual

ManualsBrandsThunder Manuals4WD & Camping100A Electronic Battery Isolator
12345678
5
Settings
There are no correct or incorrect settings for the battery isolator, the set points are
entirely dependent on the user and the required end result. The main objectives are
to protect your main cranking battery from being overly discharged (disengaging
at a reasonable voltage) and, under extreme circumstances being able to utilise
charge in the auxiliary battery to start a vehicle if the main battery has failed.
To enter the programming mode please follow these instructions:
Repeat from installation step 2 to continue to adjust all set points.
There are six (6) items that need to be set:
1. Connect - this is the voltage that the battery isolator will connect the two
batteries.
2. Connect delay - from 1-255 seconds. This setting decides the delay in time
from when the connect voltage is detected until batteries are connected.
3. Isolate - this is the voltage that the battery isolator will disconnect the
batteries from each other. This point must be lower than the connect voltage.
The default isolation point is 12.8 volts.
4. Isolate delay - from 1-255 seconds. This setting decides the delay in time
from when the isolate voltage is met to when batteries are isolated.
5. Alarm (visual) - this point must be set lower than the isolate point. Once this
point is reached the battery isolator will display 'b-L' and the optional remote
indicator light will begin to flash slowly. The LED will begin to flash fast when
the voltage drops more than 0.05 volts below the alarm set point.
6. Reset - the battery isolator can be easily reset to the factory default settings
by simply pressing the 'set' button twice This will now display the 'connect'
set point. Select the up arrow to move through all settings until all the
indicator lights on the left and right are lit and the display shows 'rSt'. Press
the 'set' button once. The screen will now show 'yes'. Using the arrow buttons
to move from 'yes' to 'no'. Select 'yes' to reset and press the 'set' button to
confirm. The battery isolator is now reset to the factory defaults.
SETTINGS
PROGRAM INSTRUCTIONS
1. PRESS “SET” This will now display the first setting.
2. PRESS “SET”
Display will flash and can be adjusted
by using the up/down arrows.
3. PRESS “SET” This enters the displayed setting.
4. PRESS “UP” ARROW
This moves the display to the next
setting.