Product Manual

BLACK WIRE Earth - Connect this wire to the chassis earth or

negative (-) battery terminal

RED WIRE Driving Light - Connect this wire to the positive (+)

output of a relay. Relay pin 87 or 87a

1. Disconnect the vehicle’s negative battery cable before commencing

any wiring.

2. Mount a suitable relay in the vehicle’s engine bay away from direct

heat and water.

3. Install a wire from the positive battery terminal to pin 30 of the relay.

This wire must be fused within 300mm from the battery.

4. Install an earth wire from the relay to pin 85 of the chassis or negative

battery terminal. Ensure a good earth connection with the chassis.

5. Install a wire from the high beam circuit of the vehicle to pin 86 of the relay.

Note, a switch should be installed in this wire to disable the driving lights

if necessary.

6. Install a wire from pin 87 of the relay to the red wire of the light bar.

7. Connect the light’s black wire to the vehicle chassis or negative terminal

of the battery.

8. Reconnect the vehicle’s negative battery cable to the battery.

9. Test the light. Turn on the vehicle’s head lights, then turn on the

high beam lights, check the switch is to the ‘ON’ position.

The light bar should illuminate.

NOTE:

Driving lights must dip with high beam lights and be separately

switched to comply with ADR.

Wiring Instructions & Wiring Steps

WIRING INSTRUCTIONS

WIRING STEPS