User Manual

22.Next drill 3/16" (5mm) holes where you marked.
Hint: It will be easier if you drill 1/8” ( 3mm) hole
first then use the 3/16” (5mm) bit to drill the hole
again.
5mm 3mm
5mm
23.Install the blind nut in place. Secure the wing bolt
all the way in with the blind nut underneath the
wing mount.
24.Install the main wing on fuselage as shown, it
should be secured perfectly.
25.Remove the wing, insert the guide tube from the
fuselage tail. Apply a drop of CA to glue the guide
tube in place.
26.Locate the guide tube bulkhead then insert the
guide tube through the bulkhead.
Push bulkhead into the fuselage just tight then
apply CA to secure bulkhead and guide tube in
place. Never push it in too hard or it may hurt the
fuselage.
ASSEMBLY / FUSELAGE