User Manual

16.Trial fit the wing mount in the fuselage, sand the
contact area with 200 grit sandpaper. This will
provide a better glue bond.
17.Glue the front and rear wing mount in place either
by thick instant glue or epoxy. The wing mounts
are flush with the opening of fuselage.
18.Locate the wing protectors, place the wing
protector where is even with the edges. Make
marks along the wing protector on the wing.
19.Remove the covering inside the mark about 1/8"
(3mm) by using hobby knife.
3mm
20.Do the same procedure on the other wing halves,
next locate the carbon rod and join the two wing
halves.
1/8" 3mm
21.Draw a center line on fuselage then place the
main wing on the fuselage. You may use masking
tape to tape two wing halves to hold them
together. Use four mounting holes as the guide to
make drill mark on the fuselage.
ASSEMBLY / FUSELAGE