User Manual

14.Next secure the Hatch Cover in place with
furnished 2x5 mm wood screws. Snap on the
clevis on control horn. Thread a small piece of
silicone tube and slide it on the clevis to prevent it
from loose.
Do the same procedure on the other wing half.
2x5 mm
15.Locate the front and rear wing mounts as well as
the doublers. Glue the doublers as shown.
12.Install the pushrod on servo horn when servo is at
neutral position. Next snap the clevis onto the
control horn link. Before using two-sided tape to
secure the servo in place, use the hatch cover as
a guide to position the servo. Make sure the servo
horn does not contact the fairing when attached.
Also make mark for the control horn hole.
13.Drill 5/64" (2mm) hole at the mark then install the
control horn and link with 2x22mm machine screw.
Make sure the control horn base does not go over
the leading edge of aileron.
2mm
ASSEMBLY / FUSELAGE
Fuselage