User Manual

3. Use heat iron to tack down the covering at the
opening. Do’nt move the leading string away until
step 6.
4. Sand the glue area of the plastic square piece
(servo bed) then CA it on the wing planking.
5. Connect the extension wire and tape the connector
to prevent from disconnecting during flight.
1. Before you install the aileron servo you have to
decide your Soaring Star have Flaperon (FLPN) or
regular Aileron control surface.
If Flaperon function is applied, then it will require 2
Servo Extensions which are 16" long minimum.
If Aileron control surface is your choice, then 2
Servo Extensions(8") plus a Y harness are
required.
FLPN
40cm
20cm
2. Cut away the covering at servo hatch, the hole
near the wing root where extension wire to go
through and mounting holes.
ASSEMBLY / WING
Wing Assembly