User Manual

Use furnished zip-tie to fix the battery pack in
place. Insert zip-tie through the laser cut slot and
go around the plywood bar then come out from
the other slot.
45.Use switch plate as a template, drill holes then
install the switch as shown.
46.Locate the canopy. Cut 1/16"(1.5mm) outside the
molded line with curved scissors. Trial fit and trim
it until it fits on the fuselage.
1.5mm
42.Refer to the manual of Electronic Speed Control
Unit (ESC-50 Shown P/N:ACE8014), link to motor,
battery and receiver. You may wrap the receiver
with sponge or thin foam pad. It will protect the
receiver and reduce the vibration from motor.
3.The attached picture is the example for using
ESC-50.
44.Apply furnished foam tap on battery mount, it will
help retaining the battery pack in place.
Rx
Motor
ACE
ESC-50
0N
OFF
Batt
Sw
7.2-8.4V Battery
ACE R/C
72
NARROW BAND
MHZ
TR-402A
4CH AM RECEIVER
CH.4
CH.2
CH.3
BATT
CH.1
ASSEMBLY / CANOPY
Canopy Installation
RX, ESC & Battery Installation