User Manual

40.What we used here are mini servos. You may use
standard servo but need to enlarge the servo tray.
The upper one is elevator servo and lower one is
rudder servo.
41.Insert the Z-Bend end to the servo control horn
then secure the servo horn onto the servo. It may
need to adjust the threaded rod and plastic tube to
get rudder and elevator at the neutral position.
Z
38.Locate the prop, spinner and screws as shown.
Assemble the folding prop first. Make sure the two
blades move freely. Insert the drive nut to the
backplate then the drive shaft. The hole of drive
nut is tapered to accommodate the drive shaft.
Secure the whole set onto motor shaft with the
nut. Do not over-tighten the nut as it might break
the aluminum drive shaft but make sure it will not
spin out when it in high rotation.
39.Make sure there is about 2~3mm(5/64"~1/8") gap
between spinner backplate and fuselage.
2~3mm
ASSEMBLY / SERVO
Servo Installation