User Manual

35.Locate the control horn base, backplate, link and

2x 22mm screw then install the control horn on the

rudder.

36.Locate the CA hinges then insert the CA hinges in

the slots of the vertical tail then glue the rudder

and CA hinge in place with thin CA.

Do the same procedure of elevator pushrod on the

rudder pushrod.

37.Locate the motor, and 3x8mm countersunk

screws. Secure the motor in the fuselage.

3x8mm

3x20mm T

33.Locate the short/ long threaded end, clevis and

plastic tube. Thread the long threaded end to

plastic tube first abut 1/4” (6mm) in length then

insert the plastic tube through the guide tube from

the bulkhead end. Get the plastic tube at the rear

of T-Tail mount then install the short threaded end

and clevis.

6mm

34.Snap the clevis onto the control horn as shown. It

may need to file the T-Tail portion to make sure the

movement is free.

A=A'

ASSEMBLY / MOTOR & PROP

Motor / Prop Installation