User Manual

30.Drill 2mm holes and install the control horn on the
tail, note it has to be in line with the tail mounting
holes and the control horn is even with the
elevator leading edge.
31.Place horizontal tail on the T-tail mount , use two
holes as the guide and make drill marks. Make
sure the drill marks are on the center line of the
Tail mount. Drill 3/32”(2mm) hole at the marks
vertically.
T T
T
2mm
32.Locate the plastic washer and 3x20mm Wood
Screw then secure the tail on the T-tail mount.
Make sure the horizontal tail is perpendicular to
the vertical tail and has same angle to the main
wing if you see from the nose.
27.Locate the plywood servo tray and supports. Glue
those supports in place with thick CA or Epoxy.
28.After it cured, slightly sand the inside of fuselage
at glue area with 200 grit sandpaper. Next slide
the servo tray in the fuselage from the front
opening, it might need to rotate the servo tray to
get in. Set the servo tray in level and make sure its
front end is 2 3/4” (70mm) away the leading edge.
Apply thick CA to glue it in place.
70mm
29.Locate the control horn and cut the control horn as
indicated.
ASSEMBLY / TAIL
Tail Installation
2 3/4" (70mm)