2.4 GHz DIGITAL PROPORTIONAL 9-CH RADIO CONTROL SYSTEM Instruction Manual No.8901 FCC ID: VEJ-COUGARGP3 More information can view the tutorial videos on our TTR official website (www.ttrobotix.com) or YouTube channel (https://www.youtube.com/user/ThunderTigerVideo) thundertiger.
Introduction Congratulations on your purchase of the Commander advanced 2.4GHz spread spectrum radio control system. This system was specifically-designed with the latest wireless and Thunder Tiger advanced-programming technology to meet R/C model requirements. With spread spectrum and smart frequency-hopping system, the Commander radio system delivers precision & reliability control without any interference risks. System Contents Transmitter Receiver Manual Features ■ 2.
Transmitter Controls 1 3 2 5 4 11 6 7 10 9 8 1. Antenna 2. Flight Mode Switch: (1) Take Off Mode: When the GPS antenna receives 7 signals from the satellite, it will switch to the GPS mode automatically. (2) Landing Assist: The Landing Assist will automatically decelerate and stabilize the drone when in landing, the function will be activated when drone is within 2M from the ground.
Radio installation Before installing your radio into your model, connect the receiver, servos, and switch harness/battery pack as shown. In addition to checking for proper operation, this "bench test" helps you become familiar with the operation of your radio. Begin by turning on the transmitter, and then turn on the receiver switch. Make sure that all servos and trims levers are operating, and take a few moments to "play" with your system.
Functions The Commander transmitter was specifically-designed to operate air models. Basic functions for this transmitter are listed below. 1. Power On a) Turn On/Off After installing the transmitter batteries, turn on the transmitter power by sliding up the switch located on the front middle position of the transmitter. The LED light turns “GREEN”. To turn off the power, slide down the switch, the LED indicator light will turn off.
3. Range-Check A built-in range-check function on the transmitter reduces signal strength for pre-flight rangecheck. When this function is activated, signal strength is weak. Use the weak signal strength for pre-flight range-check to confirm operation of wireless radio control system is normal. It is recommended to perform a complete range-check before every flight. Range-Checking” procedure: a) Turn both transmitter and model power on and ensure the system is functioning properly.
FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Additional Note for 2.4GHz Radio System CORRECT CORRECT CORRECT WRONG WRONG For best operating range, always ensure the largest section of your transmitter antenna faces the model. Warning! Operating range may be significantly reduced with the transmitter antenna pointing directly at the model! Service Thank you for purchasing the ACE RC Commander Radio. This radio was produced by Thunder Tiger Corp.
8
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
