User Manual

PB (SLA) Charge
As [Sel] flashes, press the [INC] or [DEC] buttons to select a memory position. Quickly press the [ENT] key, the memory slot position
will flash. Select a desi red current and voltage by pressing the [INC] or [DEC]. Press the [ENT] key
for 2 seconds to initiate charging.
Nicd/NiMH cycler
Quickly press the [ENT] button. The charge, discharge current and number of cycles will
flash. Press [INC] or [DEC] to change values while the screen flashes.
Press the [ENT] button for 2 seconds to begin a cycle (charge/discharge).
Number of
cycles
Press [inc] or [dec]
to check each
cycle’ data.
D: discharge
C: charge
mAh
To check cycle data during a cycle:
Press the [INC] or [DEC] button.
Note: The cutoff voltage is the same as in discharge m ode.
Discharge (Lipoly and A123 batteries)
Quickly press the [Ent] button. The cell count and discharge current will
flash. Press [INC] or [DEC] to change values while flashing. Press the
[ENT] key for 2 seconds to start discharge.
Discharge Current
Note 1: The discharge cutoff voltage can be adjusted through the system option settings (See “system option
settings”)
Note 2: We recommend Lipo and A123 discharge mode only for checking the capacity of those packs.
Note3: Discharge will be refused if the pack voltage is lower than 50% of rated capacity (approx. 3.6v/cell).
Discharge of Nicd and NiMH batteries
Quickly press the [Ent] button. The discharge current and discharge cutoff voltage will
flash. Press [INC] or [DEC] to change values while the f lashing takes place.
Press the [ENT] button for 2 seconds to initiate discharge.
Discharge
cutoff voltage
Discharge
Current
Discharge PB/SLA battery
Quickly press the [Ent] button. The pack voltage and discharge current
will flash. Press [INC] or [DEC] to change values while the f lashing
takes place. Press the [ENT] button for 2 seconds to initiate discharge.
Pack Voltage
Discharge
Current
Note: Voltage limit: 6V/12V/24. Current limit: 0.25A-1A
TP610C
7
THUNDER POWER RC
PB Discharge
12VPack D=1.0A
Nicd Discharge
6.0V D=1.0A
Lipo/A123 Discharge
3sPACK D=1.0A
Cycle Data [CL #5]
D:0000 C:0000
NiMh Cycle [CL #5]
C=1.0A D=1A
PB Charge [Sel]
12VPack C= 5.0A