User Manual

LiPo /A123 Discharge cutoff voltage settings (Lipo/A123 mode only)
Press[INC] or [DEC] to change settings.
LiPo or A123 initial charge timer:
If a pack is over discharged, the charge current will be minimized until the pack voltage
achieves a minimum s afe starting level.
Press [INC] or [DEC] to change settings.
PB (SLA) TOPOFF voltage setting (default 2.45V/Cell)
Please refer to battery manufacturers product manual.
Display cycle memory data.(Nicd/NiMH m ode only)
This function can display the stored cycle data.
“D”: Discharge capacity in mAH , “C”: Charge capacity in mAH
Press and hold [ENT] button for 2sec to clear all cycle memory slots
mAHr
System timeout setting:
The maximum operating time is adjustable between 2 and 10 hours.
Press [INC] or [DEC] to adjust (default setting is 5 hour).
**Press and hold [SEL] button for 2 seconds return to main menu screen.
MainMenuLCD Screen
Press [SEL] key : Charge > discharge > balancer checking mode (Lipo/A123 mode only)
[SEL]
[SEL]
Select memory profile M1 to M10 (all batte ry types used in same manner)
The charge mode settings can be set in any memory (25 memories) or left in previously used charge settings. Memory setting mode
can be stored at M1 to M25. The most frequently used charge settings can be stored to a specifically assigned memory slot. In normal
mode, previously used charge settings are used.
*Memory slot select
PRESS [INC] or
[DEC]]
Previously used settings
PRESS
[ENT]
Normal Mode
Memory mode
To modify charge settings:
The charge current can be changed to either a memory or normal mode. Press the [ENT] button, the present variable setting will begin
to flash. Then, press [INC] or [DEC] to change to a desired value while it continues to flash.
ChargeLipo/A123 BatteryPack
To start Charge: Select cell count and current. Then press [ENT] button for 2seconds.
**Very Important: Be sure the cell count is correct **.
Charge start
[ENT]
[ENT]
Press INC or DEC to select
The desired cell count
Press [ENT] for 2 seconds to
start charge
Press INC or DEC
to change
current setting
TP610C
4
THUNDER POWER RC
LiPo Charge
3s PACK 10.0A
LiPo Charge
3s PACK 10.0A
LiPo CHARGE
3s PACK 10.0A
LiPo/A123 Charge
3s PACK 10.0A
LiPo/123 Charge [M:20]
3s PACK 10.0A
LiPo/123 Charge [Sel]
3s PACK 10.0A
LiPo CHARGE [Mxx]
5s PACK 10.0A
LiPo Discharge
5s PACK 10.0A
Checking
Balancer >>>>>
SYSTEM TIME OUT
MAX TIME: xxHour
Cycle Data Cy:#1
D:00000 C:00000
PB Charge TOPOFF
2.45V/CELL
LiPo/A123 Init Charge
TimeOut: 10 MIN
LiPo/A123 Dchg Option
CUT OFF: 3.45V