Operation Manual

51100457 - C

4.5 InstallInG the Wheels

WARNING

Before each journey make sure that

both of the wheels are securely locked

in the carrier axle.

A. Disengage the parking brake.

B. Press and hold the wheel release button on a wheel.

C. Insert the wheel axle into an axle socket.

(See image 3)

D. Release the wheel release button.

E. Press the wheel fully into the axle socket.

F. Verify that the wheel is securely attached to the

carrier by giving it a sharp pull.

G. Repeat for the other wheel.

H. Using a tire pressure gauge check the air pressure

in each tire. The minimum recommended tire

pressure is 30 psi (2.1 bar) and the maximum is 35

psi (2.5 bar).

I. Ifairpressureistoolowineitheroneofthetiresll

them up using a bicycle tire pump.

4.4 InstallInG the ParkInG Brake

A. Lay the chassis on its roof on a clean sturdy surface.

B. With the screwdriver and 7/16" wrench remove the

locking nut and white nylon washer from the bolt on the

brake lever.

C. Insert the bolt along with the black bushing and brake

lever through the hole at the back of the chassis.

(See image 1)

D. Place the white nylon washer and the nut back onto

the bolt from inside the carrier and tighten it until one

screw thread is exposed.

E. With the wrench remove the locking nuts on both of the

bolts on the back corners of the chassis.

F. Insert the bolts on the back corners of the chassis

through the holes on the brake arms. (See image 2)

G. Place the locking nuts back onto the bolts on the back

corners of the chassis and tighten them until one thread

is exposed. (See image 2)