Operation Manual

10
51100986 - A
4.4 InstallInG the Wheels
1
WARNING
Beforeeachjourneymakesurethat
bothofthewheelsaresecurelylocked
inthecarrieraxle.
A. Pressandholdthewheelreleasebuttononawheel.
B. Insertthewheelaxleintoanaxlesocket.
(Seeimage1)
C. Releasethewheelreleasebutton.
D. Pressthewheelfullyintotheaxlesocket.
E. Verifythatthewheelissecurelyattachedtothe
carrierbygivingitasharppull.
F. Repeatfortheotherwheel.
G. Usingatirepressuregaugechecktheairpressure
ineachtire.Theminimumrecommendedtire
pressureis30psi(2.1bar)andthemaximumis35
psi(2.5bar).
H. Ifairpressureistoolowineitheroneofthetiresll
themupusingabicycletirepump.
4.5 removInG the Wheels
A. Pressandholdthewheelreleasebuttononawheel.
(Seeimage2)
B. Pullthewheeloutofthecarrieraxle.
C. Repeatfortheotherwheel.
2
4.6 InstallInG the Wheel deflectors
3
A. Installwheeldeectoronthelowerframeinfrontof
thewheelswherethere'saholeinthefabric
(Seeimage3)
B. Aligntheholeonthewheeldeectortoholeon
theframe.
C. Insertboltfromthetopthroughthealignedholes.
 (Seeimage4)
D. Tightennutsecurelytotheboltusing10mmwrench
andPhillipsscrewdriver(#3)
E. Repeatfortheotherside.
4