Thule Strolling Kit Instructions E 51100727
Parts Description Two pivoting caster wheels GENERAL WARNING These instructions contain many WARNINGS. Read and understand all of the WARNINGS. Failure to assemble and use this Thule child carrier correctly may lead to serious personal injury or death to you or your passenger. • When the Thule child carrier is used as a Bicycle Trailer, the stroller wheels must never be installed in their in-use position (wheels down). They may only be carried in their out-of-use position (wheels up).
1.1 Installing the THULE Strolling Kit 1.2 Storing the THULE Strolling Kit 1 3 . A. 2 B. C. D. A. B. C. D. Press the caster button on one of the VersaWings™ and insert the caster shaft from the top down into the caster hole. (See image 3) Repeat for the other caster wheel. Removal is the opposite to installation. Verify that the caster wheel is securely attached to the Thule child carrier by giving it a sharp pull upward. Press and hold in the caster button on one of the VersaWings™.
1.3 SERVICING THE THULE STROLLING KIT A. B. C. 4 1 3 2 4 Remove the caster wheel from the chassis. Slide the large o-ring off of the axle. (See image 1) Using the Phillips head screwdriver and 13mm/1/2in wrench, remove the bolt through the wheel and take the wheel off. (See image 2) D. E. Using a small straight-blade screwdriver, pry the c-clip off of the axle and pull the axle out.
1.3 SERVICING THE THULE STROLLING KIT (CONTINUED) 5 7 I. J. 6 F. G. H. Put the wheel back on and tighten the bolt through it. Slide a large replacement o-ring onto the axle. Lightly grease two of the small replacement o-rings and the axle. Fit the two small replacement o-rings onto the axle in the same positions as the previous ones. Do not use any tools to prevent damaging the o-rings. (See image 5) Reinstall the axle; slide a replacement c-clip back onto the axle and snap it in place using pliers.
